EarthQuaker Devices Night Wire V2

EarthQuaker Devices Night Wire V2 - Harmonic Tremolo

The brand new Night Wire is a very versatile harmonic tremolo pedal. In a harmonic tremolo, the signal is first sent through high-pass and low-pass filters and then modulated by LFOs that are offset by 180 degrees. However, the EarthQuaker Devices Night Wire goes further than conventional harmonic tremolo pedals, as the center point of both filters can be changed for different sounds. The filter frequency has three modes: Manual, LFO and Attack. In manual mode, the center point can be fixed in a desired position using the frequency control. In LFO mode, both filters are in continuous motion and the frequency control determines the speed. In Attack mode, the velocity controls the filters dynamically and the frequency control works in a similar way to a range control on an envelope filter. The tremolo section has manual and attack modes. In manual mode, the speed is set using the rate control. In Attack mode, the speed is controlled by the velocity, while Rate determines the sensitivity. The harder you strike the strings, the higher the speed and vice versa. In addition, the footswitch functions as a standard latching switch as well as a momentary switch, so that you can only use the effect for as long as you need it. The Night Wire also has an improved circuit for less background noise, a cut/boost volume control and a relay-controlled true bypass and is handcrafted in Ohio/USA.

• Harmonic Tremolo Effect Pedal
• Separate high-pass and low-pass filters
• LFOs offset by 180 degrees
• Center point of both filters can be changed for different sounds
• Footswitch functions as latching and momentary switch
• improved circuitry for less background noise
• True bypass
• Controls for Level, Depth, Rate and Frequency
• Filter frequency toggle switch with 3 modes Manual, LFO and Attack
• Tremolo section toggle switch with 2 manual and attack modes
• Bypass footswitch
• silent relay-based soft-touch switching
• Status LED
• Metal housing
• 6.3 mm mono jack input/output
• Power supply via optional 9V DC power supply 2.1 mm x 5.5 mm barrel connector, polarity (-) inside
• Battery operation not supported
• Dimensions (L x W x H): 117 mm x 64 mm x 57 mm
• Power consumption 30 mA
• Hand-made in USA

This text has been translated automatically and may contain errors.